• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
When the ignition is turned ON, the object alarm module receives the vehicle identification number (VIN) from the body control module (BCM). The object alarm module will compare the VIN received to the VIN stored in memory.
• | DTC B1325 is not set |
• | Ignition voltage is between 9-16 volts |
The VIN stored in the object alarm module does not match the received VIN.
• | Parking assist is disabled. |
• | The object alarm module commands the red indicator ON. |
• | The object alarm module sends a serial data message to the instrument panel cluster (IPC) to display SERVICE PARK ASSIST message in the driver information center (DIC) and a chime will sound. |
• | The DTC will transition to history when the fault is no longer present. |
• | A history DTC will clear after 100 malfunction-free ignition cycles. |
Object Detection Description and Operation
Control Module References for scan tool information
Verify that DTC B1015 is not set.
⇒ | If the DTC is set, program the object alarm module. Refer to Object Alarm Module Programming and Setup. If the DTC resets, replace the object alarm module. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for object alarm module replacement, setup, and programming