• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
The solenoid relay, located within the electronic brake control module (EBCM), supplies battery voltage to all of the valve solenoids.
• | Ignition voltage is greater than 9.5 volts. |
• | The solenoid relay is commanded ON. |
One or more of the following conditions exists:
• | The EBCM detects an open in the B+ circuit to the solenoid valve relay. |
• | The EBCM detects a stuck open solenoid valve relay or an open circuit between the solenoid valve relay and solenoid valves. |
• | The EBCM disables the antilock brake system (ABS), traction control system (TCS) and vehicle stability enhancement system (VSES) for the duration of the ignition cycle. |
• | The ABS indicator illuminates. |
• | The red Brake indicator illuminates. |
• | The StabiliTrak indicator illuminates. |
• | The driver information center (DIC) displays all wheel drive (AWD) OFF/Service Traction Control/Service StabiliTrak message. |
• | The condition for setting the DTC is no longer present. |
• | The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Antilock Brake System Schematics
Control Module References for scan tool information
Ignition ON, verify that DTC C0201 is not set.
⇒ | If DTC is set, replace the EBCM/BPMV. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• | Control Module References for EBCM replacement, setup, and programming |