Procedure

1. Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement.
2. Remove the 4 applique nuts from inside the liftgate panel.
3. Release the 3 upper integral retainer clips from the exterior side of the liftgate panel.
4. Disconnect the electrical connector.

1

Liftgate Center Applique Assembly Nut (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
6 N·m (53 lb in)

2

Liftgate Center Applique Assembly

Tip
Transfer the rear view camera (if equipped). Refer to Rearview Camera Replacement.

Procedure

1. Open the liftgate.
2. Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement.
3. Remove the 4 applique nuts from inside the liftgate panel.
4. Release the 2 integral retainers from the exterior side of the applique.

1

Liftgate Center Applique Assembly Nut (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
6 N·m (53 lb in)

2

Liftgate Center Applique Harness Grommet

Tip
Ensure the grommet is secure to the liftgate panel hole prior to the installation of the applique.

3

Liftgate Center Applique Assembly

Tip
Transfer the rear view camera (if equipped). Refer to Rearview Camera Replacement.

Preliminary Procedures

1. Open the liftgate.
2. Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement.
3. Remove the 4 applique nuts from inside the liftgate panel.
4. Release the 2 integral retainers from the exterior side of the applique.

1

Liftgate Center Applique Assembly Nut (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
6 N·m (53 lb in)

2

Integral Retainer (Qty: 2)

3

Rear Liftgate Harness Electrical Connector

Tip
Disconnect the electrical connector after releasing the retainers.

4

Liftgate Center Applique Assembly

Procedure

1. Pull the applique rearward in order to release the 2 outer integral clips.
2. Transfer the rear view camera (if equipped). Refer to Rearview Camera Replacement.