2
| Endgate Spoiler Adhesive Tape
Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.
Tip
- The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
- Use a
J-25070 Heat Gun
or equivalent, to remove the old spoiler. Clean all the adhesive residue from the endgate and wipe the surface dry with a clean lint-free towel prior to installing
the new spoiler.
- When removing protective liners from adhesive backed spoiler , be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
- Press the spoiler firmly to the top side of the endgate to ensure full adhesion is made to the endgate.
Special ToolsJ-25070 Heat Gun
|