Special Tools
J 24319-B Steering Linkage and Tie Rod Puller
Removal Procedure
Caution: Do not attempt to free the ball stud by using a pickle fork or wedge type tool, because seal or bushing damage could result. Use the proper tool to separate all ball joints.
- Remove the engine shield, if equipped. Refer to
Engine Shield Replacement.
Note: Discard the idler arm nut.
- Remove the idler arm nut (3) from the idler arm (1).
- Separate the idler arm (1) from the relay rod (2).
- Remove the idler arm from the relay rod using puller
J 24319-B .
- Remove the idler arm bolts (3) and the nuts (1) at the vehicle frame.
- Remove the idler arm (2) from the vehicle.
Installation Procedure
- Position the idler arm (2) to the vehicle frame.
Caution: Refer to Fastener Caution in the Preface section.
- Install the idler arm bolts (3) and nuts (1) to the frame and tighten to
105 N·m (78 lb ft).
- Install the idler arm (1) to the relay rod (2).
Note: Do not reuse the old idler arm nut.
- Install the new idler arm nut (3) to the idler arm (1) and tighten to
62 N·m (46 lb ft).
- Install the engine shield, if equipped. Refer to
Engine Shield Replacement.
- Adjust the front toe. Refer to
Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment.