• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
If the tire type and pressure selection information is not entered with the scan tool during the remote control door lock receiver (RCDLR) setup, the tire pressure monitor indicator icon on the instrument panel cluster (IPC) will flash for 1 minute and then remain illuminated after the ignition switch is cycled ON and the IPC bulb check is complete. If equipped, the driver information center (DIC) will also display a service tire monitor type message. Under these circumstances, DTC C0569 will be set and the tire type and pressure information will need to be entered for the system to function correctly.
The ignition is ON.
The RCDLR has not undergone the programming procedure.
• | The tire pressure monitor indicator icon on the instrument panel cluster (IPC) flashes for 1 minute and then remains illuminated after the ignition switch is cycled ON and the IPC bulb check is complete. |
• | If equipped, the driver information center (DIC) displays the suspect tire pressure as dashes. |
• | If equipped, the DIC displays a service tire monitor type message. |
A current DTC will clear when the RCDLR has undergone the tire type and pressure selection setup procedure and 1 ignition cycle has occurred.
A newly replaced RCDLR will set DTC C0569 after programming on its initial ignition ON cycle if the module setup information has not been entered. The Tire Type and Tire Pressure Selection setup must be performed with the scan tool.
Tire Pressure Monitor Description and Operation
Control Module References for scan tool information
Verify that the DTC C0569 is not set.
⇒ | If the DTC is set, perform the RCDLR tire type and pressure selection setup with the scan tool and cycle the ignition. If the DTC resets, replace the RCDLR. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for RCDLR replacement, setup, and programming