Removal Procedure
- Disconnect the auxiliary fluid pump wire harness (1) from the auxiliary fluid pump control module connector (2).
- Remove the auxiliary fluid pump wire harness (6) from the harness retainers (7).
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove the auxiliary fluid pump wire harness clip nut (3).
- Place a suitable drain pan under the transmission auxiliary fluid pump.
- Remove the auxiliary fluid pump bolts (1).
Notice: Do not damage the case sealing surface when removing or installing the pump and motor assembly.
- Remove the auxiliary fluid pump (2).
Notice: The auxiliary fluid pump gasket is not re-usable. Use a NEW gasket when replacing or damage may occur.
- Remove the auxiliary fluid pump gasket (3).
Installation Procedure
Notice: The auxiliary fluid pump gasket is not re-usable. Use a NEW gasket when replacing or damage may occur.
- Install the auxiliary fluid pump gasket (3).
Notice: Do not damage the case sealing surface when removing or installing the pump and motor assembly.
- Install the auxiliary fluid pump (2).
Notice: Refer to Fastener Notice in the Preface section.
- Install the auxiliary fluid pump bolts (1).
Tighten
Tighten the bolts to 9-13 N·m (80-115 lb in).
- Install the auxiliary fluid pump wire harness clip nut (3).
Tighten
Tighten the nuts to 9 N·m (80 lb in).
- Lower the vehicle.
- Install the auxiliary fluid pump wire harness (6) to the harness retainers (7).
- Connect the auxiliary fluid pump wire harness (1) to the auxiliary fluid pump control module connector (2).
Notice: Use Dexron VI transmission fluid only. Failure to use the proper
fluid may result in transmission internal damage.
- Fill the transmission with the proper amount of transmission fluid. Refer to
Fluid Capacity Specifications and
Transmission Fluid Check.