Tools Required
J 41479
Crankshaft Rear Oil Seal Installer
Removal Procedure
- Remove the automatic transmission flexplate, refer to
Automatic Transmission Flex Plate Replacement.
- Remove and discard the crankshaft rear oil seal (141).
Installation Procedure
Important: For proper orientation, note the installation direction of the oil seal. The oil seal is a reverse-lip design. The part number is applied to the outside face of the seal, as shown.
- Inspect the seal and identify the part number markings for proper orientation.
- Install the
J 41479
cone (2)
and bolts onto the rear of the crankshaft.
- Tighten the bolts until snug. Do not overtighten.
- Install the rear oil seal onto the tapered cone (2) and push the seal to the rear seal bore. Install the oil seal with the part number markings facing away from the engine.
- Thread the
J 41479
threaded rod into the tapered cone until the tool (1) contacts the oil seal.
- Align the oil seal into the tool (1).
- Rotate the handle of the tool (1) clockwise until the seal enters the rear cover and bottoms into the cover bore.
- Remove the
J 41479
.
- Install the automatic transmission flexplate, refer to
Automatic Transmission Flex Plate Replacement.