SERVICE MANUAL UPDATE SEC. 3B1 POWER STEERING RETURN HOSE

VEHICLES AFFECTED: 1989 "C"

The power steering return line assembly information in the 1989-1990 Service Information Manuals is incorrect. For proper replacement use the following procedure:

1. Remove retainer on radiator shroud and bracket on A/C accumulator.

2. Disconnect electrical connector from accumulator and reposition A/C accumulator and lines.

3. Remove serpentine belt.

4. Remove upper idler pulley.

5. Remove lower idler pulley.

6. Remove AIR retention clip at back of engine block and reposition hoses.

7. Remove power steering pulley.

8. Remove return line from pump.

9. Raise vehicle.

10. Remove pipe assembly from retention nut on engine block.

11. Remove pipe from plastic retainer on left-hand side of body.

12. Remove retention bolt from AIR pipe.

13. Remove return line from gear.

14. Remove two retainers (one at bottom of radiator shroud and one behind bumper).

15. Remove one bolt from air dam and one Christmas tree retainer for access.

16. Remove return line from car.

Reverse procedure to reinstall -

17. Bleed power steering system.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.