Catalytic Converter Replacement - Right Side LY7
Removal Procedure
Caution: Refer to Exhaust Service Caution in the Preface section.
Caution: Refer to Protective Goggles and Glove Caution in the Preface section.
- Remove the right bank exhaust manifold heat shield. Refer to
Exhaust Manifold Heat Shield Replacement - Right Side.
- Remove the catalytic converter nuts.
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Disconnect the oxygen sensor electrical connector.
- Disconnect the muffler pipe from the left and right side catalytic converters.
- Remove the exhaust pipe to right bank catalytic converter fasteners.
- Carefully remove the catalytic converter with the seal/heat shield and oxygen sensor from the exhaust manifold.
- Remove the oxygen sensor from the catalytic converter. Refer to
Heated Oxygen Sensor Replacement - Bank 1 Sensor 1.
Installation Procedure
- Install the oxygen sensor to the catalytic converter. Refer to
Heated Oxygen Sensor Replacement - Bank 1 Sensor 1.
Important: Inspect the catalytic converter seal/heat shield sealing surface. Replace the seal/heat shield if the sealing surface is worn or damaged.
- Install the catalytic converter seal/heat shield to the catalytic converter.
- Carefully install the catalytic converter to the exhaust manifold.
- Install the catalytic converter to exhaust manifold fasteners.
- Connect the oxygen sensor electrical connector.
Notice: Refer to Fastener Notice in the Preface section.
Important: Inspect the catalytic converter seal. Replace the seal if it is worn or damaged.
- Connect the muffler pipes to the left and right side catalytic converters.
Tighten
Tighten the muffler nuts to 22 N·m (16 lb ft).
- Lower the vehicle.
- Tighten the catalytic converter nuts.
Tighten
Tighten the catalytic converter nuts to 50 N·m (37 lb ft).
- Install the right bank exhaust manifold heat shield. Refer to
Exhaust Manifold Heat Shield Replacement - Right Side.