1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
3. Disconnect the electrical connector from the throttle body assembly.



4. Remove the throttle body assemble mounting bolts.
5. Remove the throttle body and throttle body gasket from the water housing.
6. Discard the throttle body gasket.

Notice: Do not use a cleaner which contains methyl ethyl ketone. This extremely strong solvent may damage components and is not necessary for this type of cleaning.

Important: Do not reuse the old throttle body gasket.

1. Install the NEW gasket to the throttle body assembly.
2. Install the throttle body assembly to the water housing.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the throttle body assembly mounting bolts.

Tighten
Tighten the bolts to 10 N·m (89 lb in).




4. Connect the electrical connector to the throttle body assembly.
5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
6. Install the fuel injection sight shield. Refer to Fuel Injector Sight Shield Replacement .