Notice: Refer to Fastener Notice in the Preface section.
- Install the oil pressure sender.
Tighten
Tighten the oil pressure sender to 20 N·m (15 lb in).
- Install the NEW oil filter cartridge.
- If the oil filter cap O-ring is removed, install a NEW O-ring on the oil filter cap.
3.1. | Ensure the O-ring groove is not damaged. Replace the oil filter cap if the O-ring groove is damaged. |
3.2. | Protect the O-ring from damage during installation by covering the threads of the oil filter cap with tape or plastic wrap. |
3.3. | DO NOT stretch the O-ring during installation. |
3.4. | Roll the O-ring into position over the covered threads. |
3.5. | Remove the tape or plastic wrap from the oil filter cap threads. |
3.6. | Ensure the oil filter cap threads are clean. |
- Lubricate the oil filter cap threads and O-ring with clean engine oil.
- Install the oil filter cap.
Tighten
Tighten the oil filter cap to 25 N·m (18 lb in).