Special Tools
Important: Ensure that the crankshaft is in the timing drive assembly position using the
EN 46111 .
- Ensure the cylinder head locating pins are securely mounted in the cylinder block deck face.
- Install a NEW right cylinder head gasket using the deck face locating pins for retention.
- Align the right cylinder head with the deck face locating pins.
- Place the right cylinder head in position on the deck face.
Notice: Refer to Fastener Notice in the Preface section.
Important: DO NOT allow oil on the cylinder head bolt bosses.
Important: DO NOT reuse the old M11 cylinder head bolts.
- Install new M11 cylinder head bolts.
Tighten
- Tighten the M11 cylinder head bolts a first pass in sequence to 30 N·m (22 lb ft).
- Tighten the M11 cylinder head bolts a second pass in sequence an additional 120 degrees using the
J 45059 .