Special Tools
J 28410 Gasket Remover
- Remove the 3 M6 external drive bolts from the front portion of the cylinder head.
Important: DO NOT reuse the M11 cylinder head bolts.
- Remove and discard the 10 M11 internal drive cylinder head bolts.
- Remove the left cylinder head. Ensure that no dowel guide pins are stuck in the cylinder head.
Important: You must clean the thread sealant material from the cylinder head bolt holes in the cylinder block. Failure to do so could cause false torque readings during reassembly.
- After removing the cylinder head, remove any remaining bolt thread sealant material from the threaded cylinder block holes.
Important: DO NOT reuse the cylinder head gasket.
- Remove the left cylinder head gasket.
- Remove all remaining gasket material from the cylinder head and cylinder block using the
J 28410 .