The battery current sensor PWM input signal is monitored by the instrument panel module (IPM).
This diagnostic procedure supports the following DTC:
DTC B1516 Battery Current Sensor Performance
This vehicle has DTCs which include DTC symptoms. For more information, refer to DTC Symptom Description .
DTC Symptom | DTC Symptom Descriptor |
---|---|
08 | Signal Invalid |
• | The ignition is in the ON position. |
• | The engine is running. |
This DTC will be set as current when the duty cycle of the PWM input signal is less than 4 percent or more than 96 percent for more than 33 seconds.
The SERVICE VEHICLE SOON warning message will be set in the drivers information center (DIC).
The DTC clears as a current status when the battery sensed current returns to normal range for more than 5 seconds.
Step | Action | Values | Yes | No |
---|---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | |
2 |
Does the scan tool indicate that the parameter is within the specified range? | <4 percent to >96 percent | Go to Step 3 | Go to Charging System Test |
3 | Inspect for poor connections at the harness connector of the battery current sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs Did you find and correct the condition? | -- | Go to Step 5 | Go to Step 4 |
4 | Replace the battery current sensor. Did you complete the replacement? | -- | Go to Step 5 | -- |
5 |
Does the DTC reset? | -- | Go to Step 2 | System OK |