Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement .
3. Remove the upper and lower valve body assembly. Refer to Control Valve Lower Body and Upper Body Replacement .
4. Disconnect the speed sensor electrical connector from the control solenoid valve assembly.

1

Notice: Refer to Fastener Notice in the Preface section.

Input and Output Speed Sensor Assembly Bolt (Qty: 2)

Tighten
12 N·m (106 lb in)

2

Input and Output Speed Sensor Assembly

Important: After an internal transmission repair or internal part replacement, the Service Fast Learn Adapt procedure should be performed. Refer to Service Fast Learn Adapts .

Tip
Disconnect the speed sensor wiring harness clips. Inspect the clips for damage. Replace if damaged.

3

Control Valve Body Assembly