Perform the instrument panel cluster setup in line with the Tech 2 instructions.

If the instrument panel module (IPM) is replaced, the following procedures must be performed:

1. Setup New IPM
2. Program vehicle identification number (VIN)
3. Brake pedal position (BPP) sensor calibration

Refer to Body Control Module (BCM) Programming/RPO Configuration.

If the inflatable restraint sensing and diagnostic module (SDM) is replaced, update the SDM number in IPM. This number is also called restraints ID and represents the last four digits of SDM part number. On the Tech 2 menu Module Setup SDM, perform Setup SDM Part Number in IPM function.

If the brake pedal position (BPP) sensor is replaced, the BPP Sensor Calibration procedure must be performed. Refer to Brake Pedal Position Sensor Calibration.