GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2008 🢒 SLS 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Electronic Suspension Front Position Sensor Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.

    3. Object Number: 1371682 Size: SH
  3. Disconnect the front ride sensor link from the upper control arm ball stud.
  4. Disconnect the front ride sensor harness connector.

    5. Object Number: 1371680 Size: SH
  5. Loosen the front ride sensor retaining nut.
  6. Gently tap the front ride sensor retaining stud in order to loosen the stud to fender connection.
  7. Remove the front ride sender from the vehicle.

Installation Procedure

    Object Number: 1371680 Size: SH
  1. Position the sensor to the vehicle.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the front ride sensor retaining nut.

    3. Tighten
    Tighten the nut to 9 N·m (80 lb in).


    Object Number: 1371682 Size: SH
  3. Connect the front ride sensor link to the upper control arm ball stud.
  4. Connect the front ride sensor harness connector.
  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation.
  6. Lower the vehicle.