GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Important: The area around the electronic brake control module (EBCM) must be free from loose dirt to prevent contamination of disassembled ABS components.


    Object Number: 773022  Size: SH
  1. Thoroughly clean all contaminants from around the EBCM.
  2. Disconnect the brake fluid pressure sensor electrical connector (3) from the brake fluid pressure sensor (2).
  3. Remove the brake fluid pressure sensor (2) from the EBCM (1).

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 773022  Size: SH
  1. Install the brake fluid pressure sensor (2) to the EBCM (1).
  2. Tighten
    Tighten the brake fluid pressure sensor to 17 N·m (13 lb ft).

  3. Connect the brake fluid pressure sensor electrical connector (3) to the brake fluid pressure sensor (2).
  4. Fill and bleed the hydraulic brake system. Refer to Master Cylinder Reservoir Filling and Hydraulic Brake System Bleeding .
  5. Perform the Auto Bleed Procedure. Refer to Antilock Brake System Automated Bleed Procedure .
  6. Perform the Diagnostic System Check - Vehicle. Refer to Diagnostic System Check - Vehicle .