Diagnostic Instructions
Circuit/System Description
The fuel level sensor changes resistance in response to the fuel level. The engine control module (ECM) monitors the signal circuit of the fuel level sensor in order to determine fuel level. When the fuel tank is full, the sensor resistance is high and
the ECM senses a high signal voltage. When the fuel tank is empty, the sensor resistance is low and the ECM senses a low signal voltage. The ECM uses the signal circuit of the fuel level sensor in order to calculate the total remaining fuel percentage in the
tank. The ECM sends the fuel level percentage via the class 2 serial data circuit to the instrument panel cluster (IPC) in order to supply the fuel gage display. The fuel level information is also used for misfire and evaporative emission (EVAP) diagnosis.
This diagnosis tests the fuel level sensor signal for an intermittent failure. If the fuel level change is detected, the action of filling the fuel can disable the engine DTC P0442 of closing the permanent vacuum slight leakage test. Before disabling
the DTC P0442, perform the test of filling the fuel action in order to ensure the fuel is refilled. If the action of filling the fuel is ensured, it indicates this test is passed. Otherwise, set a DTC P0464 to indicate an intermittent failure.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC P0464 Fuel Level Sensor Circuit Intermittent Failure
Conditions for Running the DTC
• | The ignition switch is OFF. |
Conditions for Setting the DTC
• | In the engine OFF test, the fuel level change is greater than 15 percent. |
• | The above condition is present and continues for more than 30 seconds. |
Action Taken When the DTC Sets
• | DTC P0464 is a type A DTC. |
Conditions for Clearing the DTC
DTC P0464 is a type A DTC.
Diagnostic Aids
Use the Freeze Frame/Failure Records data in order to locate an intermittent condition. If you cannot duplicate the DTC, the information included in the Freeze Frame/Failure Records data may help in determining the number of miles since the DTC set. The
Fail Counter and Pass Counter can also help in determining the number of ignition cycles that the diagnostic test reported a pass and/or fail. Operate the vehicle within the same freeze frame conditions, including those for RPM, for engine load, for vehicle
speed, for temperature, and for others.