GM Service Manual Online
For 1990-2009 cars only

Special Tools

    • J 37088-A Fuel Line Disconnect Tool Set
    • J 44581 Fuel Line Disconnect Tool

Removal Procedure

  1. Relieve the fuel system fuel pressure. Refer to Fuel Pressure Relief.
  2. Remove the retainer from the quick-connect fitting.
  3. Caution: Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.

  4. Blow dirt out of the fitting using compressed air.

  5. Object Number: 12780  Size: SH
  6. Choose the correct tool for the size and access of the fitting: J 37088-A or J 44581 . Insert the tool into the female connector, then push inward to release the locking tabs.

  7. Object Number: 12782  Size: SH
  8. Pull the connection apart.
  9. Notice: If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.

  10. Using a clean shop towel, wipe off the male pipe end.
  11. Inspect both ends of the fitting for dirt and burrs. Clean or replace the components as required.

Installation Procedure

Caution: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.

This will ensure proper reconnection and prevent a possible fuel leak.

During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.


    Object Number: 12784  Size: SH
  1. Apply a few drops of clean engine oil to the male pipe end.

  2. Object Number: 12786  Size: SH
  3. Push both sides of the fitting together to cause the retaining tabs to snap into place.

  4. Object Number: 12787  Size: SH
  5. Once installed, pull on both sides of the fitting to make sure the connection is secure.
  6. Install the retainer to the quick-connect fitting.