Removal Procedure
- Remove the fuel injector sight shield. Refer to
Fuel Injector Sight Shield Replacement.
Important: When disconnecting more than one sensor, mark the connectors to ensure correct re-installation. The electrical connectors are physically interchangeable, however, they must be installed to the correct sensor.
- Disconnect the electrical connector from the left bank intake camshaft position sensor (1).
- Remove the camshaft sensor retaining bolt.
- Remove the left bank intake camshaft sensor (3).
Installation Procedure
Important: Inspect the camshaft sensor O-ring for wear or damage. If a problem is found, replace the O-ring.
- Lubricate the camshaft sensor O-ring with engine oil.
Notice: Refer to Fastener Notice in the Preface section.
- Install the left bank intake camshaft position sensor (3) and retaining bolt.
Tighten
Tighten the retaining bolt to 10 N·m (89 lb in).
- Reconnect the camshaft sensor electrical connector (1).
- Install the fuel injector sight shield. Refer to
Fuel Injector Sight Shield Replacement.
- Operate the engine and inspect the camshaft sensor for engine oil leaks.