Caution: Refer to Glass and Sheet Metal Handling Caution in the Preface section.
Caution: Refer to Express Window Down Caution in the Preface section.
- Remove the door trim panel. Refer to
Front Side Door Hinge Replacement
or
Rear Side Door Trim Panel Replacement
.
- Pull down the upper portion of the water deflector far enough to access the window clamp nuts. Refer to
Water Deflector, Check Link Replacement - Rear Door
.
- Loosen the window regulator to window clamp nuts 4 revolutions.
- Connect the door trim panel wire connector.
Important: Start the vehicle to ensure maximum power to the window motor. This is required in order to fully seat the window for adjustment.
- Start the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
- Using the power window switch, raise the window to the full up position.
Tighten
Tighten the window clamp nuts to 11 N·m (98 lb in).
- Inspect for proper window operation and a tight seal.
- Shut off the vehicle.
- Install the water deflector. Refer to
Water Deflector, Check Link Replacement - Rear Door
.
- Install the door trim panel. Refer to
Front Side Door Hinge Replacement
or
Rear Side Door Trim Panel Replacement
.