Preliminary Procedures

1. Remove the front seats. Refer to Driver or Passenger Seat Replacement .
2. Remove the front seat switch trim panel assembly. Refer to Power Seat Switch Replacement .
3. Recalibrate SIR passenger pressence system. After any parts of seat cushion or passenger presence system is removed, refer to Inflatable Restraint Sensing and Diagnostic Module Programming and Setup .

1

Front Seat Frame Retaining Nut (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
9  N·m(80 lb in)

2

Front Seat Cushion Cover

Procedure:

1. Disconnect the electrical connector and remove the seat cushion.
2. Loose J-channel retainer and two side clips. Remove the front seat cushion cover. Notice the alignment of the cover and the seat cushion when installing the seat cushion cover.

3

Front Seat Blower Retaining Bolt (Qty: 2)

Tighten
3N·m(25 lb in)

4

Front Seat Blower

Tip
Remove the blower from heater directly.

5

Front Seat Heater

Tip
Thread the heater through the front seat cushion frame and pad, separate the heater from the front seat cushion and pad.

6

Front Seat Cushion and Pad, Frame

Tip
Separate the front seat cushion frame and pad.