GM Service Manual Online
For 1990-2009 cars only

Special Tools

J 24319-B Steering Linkage and Tie Rod Puller

Removal Procedure


    Object Number: 1209258  Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
  3. Remove the shock absorber yoke retaining nut.
  4. Remove the shock absorber yoke retaining bolt by pulling up slightly on the lower control arm to remove the pressure on the bolt.

  5. Object Number: 874633  Size: SH
  6. Remove the yoke to lower control arm retaining nut.

  7. Object Number: 743091  Size: SH
  8. Using the J 24319-B . Separate the yoke from the lower control arm.

  9. Object Number: 874641  Size: SH
  10. Remove the yoke from the vehicle.

Installation Procedure


    Object Number: 874641  Size: SH
  1. Install the yoke to the vehicle.
  2. Important: Do not tighten the nut at this time.

  3. Install the yoke to lower control arm retaining nut.

  4. Object Number: 1209258  Size: SH
  5. Install the yoke to the shock.
  6. Notice: Refer to Fastener Notice in the Preface section.

  7. Install the yoke to shock retaining bolt and nut.
  8. Tighten

        • Tighten the nut to 86 N·m (63 lb ft)
        • Tighten the yoke to lower control arm nut to 180 N·m (133 lb ft)
  9. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation.
  10. Lower the vehicle.