Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Remote Function Schematics Connector End View Reference: Remote Function Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Press each button of the transmitter one at a time. Is the system OK? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 | Use the vehicle interior controls to perform the Lock and Unlock operation on the door lock. Is the door lock operating normally? | Go to Step 4 | Go to Symptoms - Doors |
4 | Operate the rear compartment release and the fuel door release from the controls inside the vehicle. Does the rear compartment release and the fuel door release operate properly? | Go to Step 5 | Go to Symptoms - Body Rear End |
5 |
Important: Ensure that the keyless entry transmitter is the correct model for the vehicle remote system. A wrong model transmitter may pass this test, but will not activate the keyless entry system.
Does a tone sound and the green light illuminate on the J 43241 after each button is pressed? | Go to Step 10 | Go to Step 6 |
6 | Do any of the buttons on the transmitter sound the tone and illuminate the green light when pressed? | Go to Step 9 | Go to Step 7 |
7 | Replace the transmitter battery. Refer to Transmitter Battery Replacement . Is the replacement complete? | Go to Step 8 | -- |
8 |
Does a tone sound and the green light illuminate on the J 43241 after each button is pressed? | Go to Step 10 | Go to Step 9 |
9 | Replace the keyless entry transmitter. Refer to Transmitter Programming . Is the replacement complete? | Go to Step 10 | -- |
10 | Perform the programming procedure. Refer to Transmitter Programming . Does the DIC sound a chime and display the Programming Next Key Available to Begin information? | Go to Step 12 | Go to Step 11 |
11 | Replace the remote control door lock receiver (RCDLR). Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 12 | -- |
12 | Operate the system to verify the repair. Is the failure removed? | System OK | Go to Step 3 |
Step | Action | Yes | No | ||||
---|---|---|---|---|---|---|---|
Schematic Reference: Remote Function Schematics Connector End View Reference: Remote Function Connector End Views | |||||||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |||||
2 | Approach the vehicle with the keyless entry transmitter and attempt to open each door and the rear compartment. Do all doors and the rear compartment open? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 | ||||
3 | Do any doors or the rear compartment open? | Go to Step 4 | Go to Step 5 | ||||
4 |
Important:
Was an AC voltage signal captured on the DMM? | Go to Step 7 | Go to Step 6 | ||||
5 | Test the passive portion of the transmitter:
Does the J 43241 beep when attempting to open each door and the rear compartment? | Go to Step 8 | Go to Step 9 | ||||
6 | Test the affected antenna's keyless entry antenna signal and low reference circuit for an open or a short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 14 | Go to Step 8 | ||||
7 | Inspect for poor connections at the affected keyless entry antenna. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | Go to Step 14 | Go to Step 12 | ||||
8 | Inspect for poor connections at the RCDLR. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | Go to Step 14 | Go to Step 13 | ||||
9 | Replace the transmitter battery. Refer to Transmitter Battery Replacement . Did you find and correct the condition? | Go to Step 14 | Go to Step 10 | ||||
10 | Replace the keyless entry transmitter. Refer to Transmitter Programming . Is the replacement complete? | Go to Step 11 | -- | ||||
11 |
Important: All transmitters which are to be recognized by the RCDLR must be programmed in a single programming sequence. Perform the transmitter programming procedure. Refer to Transmitter Programming . Does the DIC sound a chime and display the Programming Next Key Available to Begin information? | Go to Step 14 | Go to Step 13 | ||||
12 | Replace the affected keyless entry antenna. Refer to Ignition Lock Key Transmitter Antenna Replacement - Floor Console , Ignition Lock Key Transmitter Antenna Replacement - Headliner and Ignition Lock Key Transmitter Antenna Replacement - Rear Compartment . Is the replacement complete? | Go to Step 14 | -- | ||||
13 | Replace the Remote Control Door Lock Receiver (RCDLR). Refer to Control Module References for replacement, setup, and programming. Is the replacement complete? | Go to Step 14 | -- | ||||
14 | Operate the system to verify the repair. Is the failure removed? | System OK | Go to Step 3 |