Special Tools

1. Remove the right camshaft cover. Refer to Camshaft Cover Replacement - Right Side.
2. Remove the engine oil pump. Refer to Oil Pump Replacement.



3. Align the primary timing marks (1) using the J 39946 .



4. Install the EN 46328  (1) on the right bank camshafts (2).



5. Create two reference marks (1) using a paint stick to identify the chain link adjacent to each actuator timing mark (2, 3).



6. Install an engine front cover bolt (2) into the front of the engine.

Note: Securing the right secondary camshaft drive chain shoe will prevent the right camshaft drive sprocket teeth from skipping on the right secondary timing chain.

7. Wrap mechanics wire (1) tightly around both the right secondary camshaft drive chain shoe (3) and the front cover bolt (2).



8. Remove the 2 bolts attaching the right secondary camshaft drive chain tensioner to the engine block.
9. Remove the right secondary camshaft drive chain tensioner, allowing the tensioner to expand as you remove it.
10. Clean and inspect the camshaft timing drive components. Refer to Camshaft Timing Drive Components Cleaning and Inspection.

1. Collapse the right secondary camshaft chain tensioner using the following procedure:

1.1.	Rotate the ratchet release lever (2) counterclockwise and hold.

1.2.	Collapse the tensioner shoe (1) and hold.

1.3.	Release the ratchet lever (2).

2. Slowly release the pressure on the shoe (1), until the ratchet lever (2) moves to the first detent and a "click" is heard and felt.
3. Collapse the tensioner shoe (1) and hold.



4. Insert a pin through the hole in the release lever in order to lock the tensioner shoe in the collapsed position.

Caution: Refer to Fastener Caution in the Preface section.





Note: Ensure the tensioner release lever is facing outward.

5. Install the right secondary camshaft drive chain tensioner and retaining bolts.

Tighten
Tighten the secondary camshaft drive chain tensioner bolts to 25 N·m (18 lb ft).

6. Remove the pin holding the tensioner to tighten any slack in the timing chain.



7. Inspect the two paint marks (1, 3) created previously to ensure they remain aligned with the timing marks (2, 4) on the actuator.



8. Remove the mechanics wire (1) supporting the right secondary camshaft drive chain shoe (3).
9. Remove the engine front cover bolt (2) from the front of the engine.
10. Install the engine oil pump. Refer to Oil Pump Replacement.



11. Remove the EN 46328  (1).
12. Install the right camshaft cover. Refer to Camshaft Cover Replacement - Right Side.