1

Low and Reverse Clutch Backing Plate Retaining Ring

2

Low and Reverse Clutch Backing Plate

3

Low and Reverse Clutch Plate Assembly (Qty: 6)

4

Low and Reverse Clutch Plate (Qty: 6)

5

Low and Reverse Clutch (Waved) Plate

1

Low and Reverse Clutch Spring Retaining Ring

Caution: DT-49122 must be used with the DT-48069 in order to prevent damage to the low clutch sprag retainer.

Special Tools

DT-48069 Low Clutch Spring Compressor

2

Low Clutch Sprag Assembly

3

Low and Reverse Clutch Spring

4

Low and Reverse Clutch Piston Assembly

Tip
It may be necessary to apply air to the apply passage in order to unseat the piston.

5

Low Clutch Sprag Seal

Caution: Refer to Seal Reuse Caution in the Preface section.

1

Low and Reverse Clutch Piston Assembly

Tip
Lubricate the inner and outer sealing surfaces of the piston assembly with automatic transmission fluid (ATF) in order to ease installation into the center support assembly.

2

Low Clutch Sprag Seal

Caution: Refer to Seal Reuse Caution in the Preface section.

Tip
Apply ATF to the DT-48070 to ease seal installation.

Special Tools

DT-48070 Low Clutch Sprag Seal Cone

3

Low and Reverse Clutch Spring

Caution: Ensure the spring tabs are facing up during installation. Failure to do so may cause damage to the clutch assembly.

4

Low Clutch Sprag Assembly

Tip

5

Low and Reverse Clutch Spring Retaining Ring

Caution: Care must be taken so that the boots are not twisted when rotating the inner tie rod, or damage to the boots may result.

Caution: The retaining ring gap must be aligned with the 3 missing splines on the center support hub. Failure to do so may cause damage to the clutch assembly.

Special Tools

1

Low and Reverse Clutch (Waved) Plate

2

Low and Reverse Clutch Plate (Qty: 6)

3

Low and Reverse Clutch Plate Assembly (Qty: 6)

4

Low and Reverse Clutch Backing Plate

5

Low and Reverse Clutch Backing Plate Retaining Ring

Tip
Apply air to verify proper installation of all low and reverse clutch components.