Removal Procedure
- Remove the drive flange (2) and seal (3). Refer to
Drive Flange and Seal Replacement.
- Place a suitable jack under the transmission pan in order to support the transmission.
- Remove the transmission support. Refer to
Transmission Support Replacement.
- Place a drain pan under the extension housing.
- Remove the extension housing bolts (35).
- Remove the extension housing (27) and seal (25).
Installation Procedure
Note: The case extension gasket seal is reusable. Replace the gasket ONLY if the sealing surface is damaged.
- Install the extension housing (27) and seal (25).
Caution: Refer to Fastener Caution in the Preface section.
- Install the extension housing bolts.
Tighten
Tighten the bolts to 22 N·m (16 lb ft).
- Install the transmission support. Refer to
Transmission Support Replacement.
- Remove the transmission jack.
- If equipped with RWD, install the drive flange (2) and seal (3). Refer to
Drive Flange and Seal Replacement.