1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief.

Warning: Wear safety glasses when using compressed air in order to prevent eye injury.

2. Blow dirt out of the fitting using compressed air.



3. Squeeze the plastic tabs of the male end connector.



4. Pull the connection apart.

Caution: Use an emery cloth in order to remove rust or burrs from the fuel pipe. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface.

5. Using a clean shop towel, wipe off the male pipe end.
6. Inspect both ends of the fitting for dirt and burrs.
7. Clean or replace the components as required.

Warning: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.

1. Apply a few drops of clean engine oil to the male pipe end.



2. Push both sides of the quick-connect fitting together in order to cause the retaining tabs/fingers to snap into place.



3. Pull on both sides of the quick connect fitting in order to make sure the connection is secure.