GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Cadillac
🢒
2009
🢒
SLS
🢒
Power and Signal Distribution
🢒
Wiring Systems and Power Management
🢒 Knock Sensor Replacement - Bank 2
Removal Procedure
Turn the ignition OFF.
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
Remove the wiring harness heat shield from the oil level indicator tube to gain access.
Remove the knock sensor (KS) electrical connector.
Remove the KS bolt.
Remove the knock sensors.
Installation Procedure
Install the KS.
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the KS bolt and tighten to
23 N·m (17 lb ft)
.
Install the KS electrical connector.
Install the wiring harness heat shield to the oil level indicator tube.
Lower the vehicle.