Important: If the sunroof actuator is the only part being serviced, follow the power sunroof actuator replacement procedure for the sunroof actuator to sunroof window timing. Refer to
Sunroof Motor/Actuator Replacement.
Important: A new replacement power sunroof actuator is set to the fully closed and flush position at the factory.
- Remove the sunroof window. Refer to
Sunroof Window Replacement.
- Fabricate a gage (2) 46.8 +/- 0.5 mm (1.84 in) wide (A).
A piece of thick paper will work.
- Set the gage into the track near the rear of the opening between the move drive slide (1) and the bracket.
- Move the drive slide fore or aft in order to get the proper setting.
- Repeat steps 3 and 4 for the other side.
- Install the sunroof window. Refer to
Sunroof Window Replacement.
- Install the sunroof actuator. Refer to
Sunroof Motor/Actuator Replacement.
- Operate the sunroof through all functions to ensure proper operation.