GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 SLS 🢒 Preface 🢒 Dangers, Warnings, and Cautions 🢒 Sunroof Window Height and Opening Fit Adjustment

    Object Number: 786921 Size: SH
  1. Cycle the sunroof window from the full open to the full closed position.

    2. Note: Correct adjustment cannot be achieved if the sunroof window is closed from the vent position.

  2. Fully cycle and close the sunroof window.
  3. Disconnect the top side of the sunroof panel side opening closeout panel covers (5) from the 3 clips located on the inner edge of the sunroof window (1,3,4) in order to access the window adjustment screws (2,6).
  4. Tape the side opening closeout panels in a downward position prior to adjusting the window.

    5. Object Number: 468350 Size: SH
  5. Loosen the 2 adjusting screws (1) on each side of the sunroof window.
  6. Center the window front to rear in the opening.

    7. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 468352 Size: SH
  7. Adjust the front of the sunroof window (2) from flush to 1 mm (0.04 in) (1) below the top surface of the roof panel (3).

    8. Tighten
    Tighten the adjustment screws to 4.5 N·m (40 lb in).


    Object Number: 758139 Size: SH
  8. Adjust the rear of the sunroof window (2) from flush to 1 mm (0.04 in) above the top surface of the roof panel (1).

    9. Tighten
    Tighten the adjustment screws to 4.5 N·m (40 lb in).


    Object Number: 786923 Size: SH
  9. Remove the tape from the sunroof panel side opening closeout covers (2).

    10. Object Number: 786921 Size: SH
  10. Connect the side opening closeout panel covers (5) to both sides of the sunroof window clips (1,3,4).
  11. Cycle the sunroof window through all of the positions.
  12. Verify the sunroof window fore/aft adjustment.
  13. Verify the front and rear height adjustment.
  14. Readjust the sunroof window, if necessary.