Preliminary Procedures

1. Remove the retainers from the top of the front fascia on the side the headlamp is being serviced in order to slightly flex the upper portion of the fascia forward to assist in headlamp removal.
2. Remove the front fender fascia extension. Refer to Front Bumper Fascia Extension Replacement.
3. Loosen the bolt securing the lower front fender to the upper front corner of the fascia from inside the wheelhouse.
4. Flex the inboard corner of the fascia far enough to remove the lower inboard headlamp bolt.
5. Turn the headlamp assembly slightly outward far enough to clear the front fascia. Give the headlamp a quick pull in order to disengage the headlamp from the lower front fender retainer.
6. Disconnect the headlamp electrical connector.

1

Headlamp Front Fender Nut

Notice: Refer to Fastener Notice in the Preface section.

Tighten
6 N·m (53 lb in)

2

Headlamp Push Pin Retainer

3

Headlamp Screw

Tighten
2 N·m (18 lb in)

4

Headlamp Screw

Tighten
2 N·m (18 lb in)

5

Headlamp Assembly