GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2005 🢒 SRX 🢒 Body 🢒 Roof 🢒 Sunroof Wiring Harness Replacement

Removal Procedure
  1. Remove the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
  2. Remove the center window panel. Refer to Sunroof Window Replacement .

    3. Important: Note how the electrical harness is routed and secured to the cable tubes in the motor/actuator compartment.

  3. Cut the tie straps that secure the electrical harness in the motor/actuator compartment to the drive and return cable tubes.
  4. Disconnect the electric harness connectors from the window and sunshade motor/actuators.
  5. Remove the lower C-pillar to electrical harness clip.
  6. Disconnect the main sunroof body harness electrical connectors.

    7. Object Number: 903802 Size: SH
  7. Pull the sunroof wiring harness (1) down from the motor/actuator compartment (2) into the interior of the vehicle.
  8. Remove the electrical harness from the vehicle.

Installation Procedure

    Object Number: 903804 Size: SH
  1. One connector at a time (1), pass the electrical harness (4, 3, 2) through the routing hole into the right side of the motor/actuator compartment.

    2. Important: Route and secure the electrical harness prior to removal.


    Object Number: 903805 Size: SH
  2. Route the connectors (3) under the cable drive tubes.

    3. Object Number: 903519 Size: SH
  3. Connect the harness (3, 5, 7, 8) to the appropriate motor/actuators.
  4. Secure the harness to the cable drive tubes with new tie straps.
  5. Use a new tie strap to secure the main body electrical harness to the lower C-pillar.

    6. Object Number: 903372 Size: SH
  6. Connect the harness connectors (1, 2, 3) to the main body harness.
  7. Install the center window (2). Refer to Sunroof Window Replacement .
  8. Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
  9. Perform the following initialization processes:
    10. • The sunroof rear window. Refer to Sunroof Rear Window Initialization Process .
    • The front window/sunshade. Refer to Sunroof Front Window/Sunshade Initialization Process .
    • The rear vent window sunshade. Refer to Sunroof Rear Window Initialization Process .
  10. Verify the correct operation of the sunroof.