For 1990-2009 cars only
Removal Procedure
- Remove the rear seat no. 1. Refer to Rear Seat Replacement.
- Remove the rear seat no. 2. Refer to Rear Number 2 Folding Seat Replacement.
- Remove the rear carpet retainers. Refer to Rear Carpet Retainer Replacement .
- Remove the rear sill plate. Refer to Rear Compartment Sill Trim Plate Replacement.
- Remove the body side rear trim panels. Refer to Body Side Rear Trim Panel Replacement .
- Remove the rear carpet (1) from the vehicle.
Caution: Refer to SIR Caution in the Preface section.
Caution: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.
Installation Procedure
- Place the carpet (1) into the vehicle.
- Ensure the electrical connectors are exposed above the carpeting.
- Secure the rear carpet hook and latch material to the intermediate carpet in four places.
- Press the carpet to the floorpan in order to remove any distortion from the carpet.
- Install the body side trim panels. Refer to Body Side Rear Trim Panel Replacement .
- Install the rear sill plate. Refer to Rear Compartment Sill Trim Plate Replacement.
- Install the rear carpet retainers. Refer to Rear Carpet Retainer Replacement .
- Install the rear seat no. 2. Refer to Rear Number 2 Folding Seat Replacement.
- Install the rear seat no. 1. Refer to Rear Seat Replacement.
Caution: All floor pan insulator material must meet Federal Vehicle Safety Standards for flammability. Failure to do so could result in personal injury and/or vehicle damage.
Caution: In order to avoid personal injury or vehicle damage when you repair or replace the carpet, use the same thickness and material size as the original installation. Always return the carpet to the original location.
