Removal Procedure
- Remove the cross vehicle brace, if necessary. Refer to
Cross Vehicle Brace Replacement
.
- Clean the fuel injector sight shield at the power steering and engine oil fill cap locations.
- Remove the power steering and engine oil fill caps.
- Lift the sight shield up from the front and pull forward to disengage the rear tab from the bracket.
Installation Procedure
- Align the rear tab with the slot in the rear bracket and push the sight shield inward to engage.
- Push the sight shield down and align the ball studs on the engine with the holes in the sight shield.
- Install the power steering and engine oil fill caps.
- Install the cross vehicle brace, if necessary. Refer to
Cross Vehicle Brace Replacement
.