Liquid Line Replacement w/C57

1. Recover the refrigerant from the system. Refer to Refrigerant Recovery and Recharging .
2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
3. Remove the surge tank. Refer to Radiator Surge Tank Replacement .
4. Disconnect the electrical connector from the wiper motor.
5. Disconnect the engine harness electrical connector.
6. Remove the surge tank outlet hose bracket nuts from the cowl.
7. Reposition the surge tank outlet hose.
8. Remove the brake booster. Refer to Power Vacuum Brake Booster Replacement .
9. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .



10. Remove the liquid line quick connect fitting from the condenser tube. Refer to Air Conditioning Line/Tube Connector Removal/Replacement .
11. Disconnect the liquid line from the condenser tube.



12. Remove the liquid line quick connect fitting (1) from the evaporator. Refer to Air Conditioning Line/Tube Connector Removal/Replacement .
13. Disconnect the liquid line from the evaporator.
14. Remove and discard the O-rings from the liquid line. Refer to O-Ring Replacement .

1. Install new O-rings to the liquid line. Refer to O-Ring Replacement .
2. Connect the liquid line to the evaporator.
3. Install a quick connect fitting (1) to the liquid line at the evaporator. Refer to Air Conditioning Line/Tube Connector Removal/Replacement .
4. Connect the liquid line to the condenser tube.
5. Install a quick connect fitting to the liquid line at the condenser. Refer to Air Conditioning Line/Tube Connector Removal/Replacement .
6. Install the brake booster. Refer to Power Vacuum Brake Booster Replacement .
7. Reposition the surge tank outlet hose to the installed position.



8. Install the surge tank outlet hose bracket nuts to the cowl.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tighten
Tighten the nuts to 9 N·m (80 lb in).

9. Connect the engine harness electrical connector.
10. Connect the electrical connector to the wiper motor.
11. Install the surge tank. Refer to Radiator Surge Tank Replacement .
12. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
13. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
14. Leak test the fittings of the component using J 39400-A .