- Install the water outlet housing bolts (382,
388) into the water outlet housing. Ensure the longest bolt is installed in the lower left position (388).
- Install the water outlet housing gaskets to the water outlet housing.
- Place the water outlet housing in position to the cylinder heads while installing the bypass hose onto the
engine front cover.
Notice: Refer to Fastener Notice in the Preface section.
- Install the water outlet housing bolts into the cylinder heads.
Tighten
Tighten the water outlet housing bolts to 25 N·m (18 lb ft).
- Place the bypass hose clamps into position.
- Ensure that the plenum duct is fully attached to the front of the intake manifold.
Tighten
Tighten the plenum duct clamp (1) to 2.25 N·m (20 lb in).
- Install a NEW throttle body gasket.
- Install the throttle body to the water outlet.
- Install the throttle body bolts.
Tighten
Tighten the throttle body bolts to 10 N·m (89 lb in).
- Install the evaporative emission (EVAP) purge valve tube onto the EVAP purge solenoid.