Caution: If a window is cracked but still intact, crisscross the window with
masking tape in order to reduce the risk of damage or personal injury.
Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
- Open the liftgate.
Notice: In order to avoid damaging the antenna lead connector, follow these
guidelines:
| • | Use a plastic tool and carefully pry the connector from the window. |
| • | Do NOT pull on the connector, which may be stuck to the urethane
adhesive or the headliner. |
- Disconnect the antenna lead located on the rear quarter window, if equipped.
- Disconnect the OnStar® connector located on the rear quarter window, if equipped.
Caution: If broken glass falls into the defroster outlets, it can be blown into
the passenger compartment and cause personal injury.
- Cover the following parts to protect from broken glass:
| 4.2. | The defroster outlets and A/C outlets |
| 4.3. | The seats and carpeting |
Caution: When working with any type of glass or sheet metal with exposed or rough
edges, wear approved safety glasses and gloves in order to reduce
the chance of personal injury.
- Remove the quarter window reveal molding (1) using a utility knife to cut around the window.
Important: Keep the cutting edge of the tool against the window.
- Separate the urethane adhesive from the window.
| • | Leave a base of urethane on the pinch-weld flange. |
| • | The only suitable lubrication is clear water. |
- With the aid of an assistant, remove the stationary window from the pinch-weld flange.
