GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2008 🢒 SRX 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Auxiliary Blower Motor Resistor Replacement

Removal Procedure

    Object Number: 1342278 Size: SH
  1. Remove the left body side trim access panel.
  2. Disconnect the electrical connector from the blower motor resistor.

    3. Object Number: 1342267 Size: SH
  3. Remove the blower motor resistor screws from the HVAC module.
  4. Remove the blower motor resistor from the vehicle.

Installation Procedure

    Object Number: 1342267 Size: SH
  1. Install the blower motor resistor.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the blower motor resistor screws.

    3. Tighten
    Tighten the screws to 1 N·m (9 lb in).


    Object Number: 1342278 Size: SH
  3. Connect the electrical connector to the blower motor resistor.
  4. Install the left body side trim access panel.