GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2008 🢒 SRX 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Inside Air Temperature Sensor Replacement

Inside Air Temperature Sensor Replacement Left Hand Drive

Removal Procedure

    Object Number: 1369936 Size: SH
  1. Remove the knee bolster. Refer to Knee Bolster Replacement.
  2. Disconnect the aspirator hose from the HVAC module.

    3. Object Number: 760802 Size: SH
  3. Remove the inside air temperature sensor (2) from the I/P by gently prying outward.
  4. Disconnect the inside air temperature sensor (2) electrical connection (1).
  5. Disconnect the aspirator hose (3) from the inside temperature sensor (2).
  6. Remove the inside air temperature sensor (2).

Installation Procedure
  1. Install the inside air temperature sensor (2).
  2. Connect the aspirator hose (3) to the inside temperature sensor (2).

    3. Object Number: 760802 Size: SH
  3. Connect the inside air temperature sensor electrical connector (1).

    4. Important: Assure that the foam seal tape is in place and covering the openings on the sides of the grille assembly (2).

  4. Install the inside air temperature sensor (2) into the I/P.

    5. Object Number: 1369936 Size: SH
  5. Connect the aspirator hose to the HVAC module.
  6. Install the knee bolster. Refer to Knee Bolster Replacement.

Inside Air Temperature Sensor Replacement Right Hand Drive

Removal Procedure

    Object Number: 1856824 Size: SH
  1. Remove the knee bolster. Refer to Knee Bolster Replacement.
  2. Disconnect the aspirator hose from the HVAC module.

    3. Object Number: 760802 Size: SH
  3. Remove the inside air temperature sensor (2) from the I/P by gently prying outward.
  4. Disconnect the inside air temperature sensor (2) electrical connection (1).
  5. Disconnect the aspirator hose (3) from the inside temperature sensor (2).
  6. Remove the inside air temperature sensor (2).

Installation Procedure
  1. Install the inside air temperature sensor (2).
  2. Connect the aspirator hose (3) to the inside temperature sensor (2).

    3. Object Number: 760802 Size: SH
  3. Connect the inside air temperature sensor electrical connector (1).

    4. Important: Assure that the foam seal tape is in place and covering the openings on the sides of the grille assembly (2).

  4. Install the inside air temperature sensor (2) into the I/P.

    5. Object Number: 1856824 Size: SH
  5. Connect the aspirator hose to the HVAC module.
  6. Install the knee bolster. Refer to Knee Bolster Replacement.