GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2008 🢒 SRX 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Sunshade Replacement

Removal Procedure
  1. Detach the sunshade (1) from the sunshade rod retainer clip.
  2. Remove the windshield pillar garnish molding. Refer to Windshield Pillar Garnish Molding Replacement .

    3. Object Number: 734901 Size: SH
  3. Remove the fasteners from the outboard bezel (2).

    4. Object Number: 708260 Size: SH

    Important: The sunshade bezel is secure to the roof by means of a two piece plastic retainer and metal integral clip.

  4. The plastic retainer will fall out of the headliner when the three fasteners are removed from the bezel.

    5. Notice: Use care when removing and installing the headliner. If reusing the headliner lay the headliner down flat on a clean surface. Excessive bending will damage the headliner.


    Object Number: 708358 Size: SH
  5. Carefully reach inside the headliner until the electrical connector (1) is exposed.
  6. Disconnect the electrical connector.
  7. Remove the sunshade from the vehicle.

Installation Procedure
  1. Position the sunshade to the headliner.

    2. Object Number: 708358 Size: SH
  2. Push the electrical connector and the wiring through the hole in the headliner.
  3. Connect the electrical connector (1).
  4. Position the plastic retainer (2) over the top of the electrical harness.
  5. Align the fasteners to the holes in the sunshade metal integral clip (2).

    6. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 734901 Size: SH

    Important: Do not pinch the wiring (3) when you install the fasteners.

  6. Install the fasteners that secure the bezel (2) to the headliner.

    7. Tighten
    Tighten the fasteners to 2 N·m (18 lb in).

  7. Install the windshield pillar garnish molding. Refer to Windshield Pillar Garnish Molding Replacement .
  8. Secure the sunshade to the sunshade rod retainer.