Removal Procedure
- Remove the closeout/insulator panel from under the dashboard on the drivers side. Refer to
Instrument Panel Insulator Panel Replacement - Right Side.
Notice: Handle the electronic throttle control components carefully. Use cleanliness
in order to prevent damage. Do not drop the electronic throttle control components.
Do not roughly handle the electronic throttle control components. Do
not immerse the electronic throttle control components in cleaning solvents
of any type.
- Disconnect the accelerator pedal position (APP) sensor electrical connector from the accelerator pedal module.
- Remove the nuts from the APP sensor mounting plate and remove from front of dash.
Installation Procedure
- Install the APP sensor to the front of dash.
Notice: Refer to Fastener Notice in the Preface section.
- Install the APP sensor mounting nuts.
Tighten
Tighten the APP sensor nuts to 9 N·m (80 lb in).
- Connect the APP sensor electrical connector.
- Operate the accelerator pedal and observe the APP angles using a scan tool. The accelerator pedal should operate freely, without binding between closed throttle and wide open throttle.
- Install the closeout/insulator panel. Refer to
Instrument Panel Insulator Panel Replacement - Right Side.