Tools Required
J 43631 Ball Joint Remover
Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle .
- Remove the tire and wheel. Refer to
Tire and Wheel Removal and Installation.
- Remove the air deflector. Refer to
Front Air Deflector Replacement .
- Remove the shock module yoke from the lower control arm. Refer to
Front Shock Absorber Yoke Replacement .
Notice: The ball stud must not rotate during disassembly or reassembly. Hand tools must be used to keep the ball stud from rotating. If air tools
are used and the stud is allowed to rotate, damage to the ball stud and/or stud mounting hole may occur.
- Remove the stabilizer shaft link lower retaining nut.
- Remove the stabilizer shaft link from the lower control arm.
- Remove the ABS wire harness from the lower control arm.
- Remove the lower control arm to steering knuckle nut.
- Using the
J 43631 , separate the lower control arm from the steering knuckle.
Important: Will need to raise the power steering gear to have clearance when removing the rear lower control arm to frame retaining bolt.
- Loosen the power steering gear retaining bolts and raise the power steering gear.
- Remove the lower control arm to cradle nuts.
- Remove the lower control arm to cradle bolts.
- Remove the lower control arm by lowering the lower control arm at the frame and moving the ball stud upwards.
Installation Procedure
- Install the lower control arm by installing the lower control arm on the ball stud and moving the lower control arm up to the cradle.
- Install the lower control arm to cradle bolts.
Notice: Refer to Fastener Notice in the Preface section.
- Install the lower control arm to cradle nuts.
Tighten
Tighten the nuts to 135 N·m (96 lb ft).
- Tighten the power steering gear retaining bolts.
Tighten
Tighten the bolts to 120 N·m (89 lb ft).
- Install the lower control arm to steering knuckle nut.
Tighten
- Tighten the nut to 20 N·m (15 lb ft).
- Tighten the nut to an additional 210 degrees.
- Install the ABS wire harness to the lower control arm.
- Install the stabilizer shaft link to the lower control arm.
- Install the stabilizer shaft link lower retaining nut.
Tighten
Tighten the nut to 110 N·m (81 lb ft).
- Install the shock module yoke to the lower control arm. Refer to
Front Shock Absorber Yoke Replacement .
- Install the air deflector. Refer to
Front Air Deflector Replacement .
- Install the tire and wheel. Refer to
Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Align the front end. Refer to
Wheel Alignment Measurement .