Removal Procedure
- Raise the window to the full up position.
- Remove the door trim panel. Refer to
Front Side Door Trim Panel Replacement
.
- Remove the water deflector. Refer to
Front Side Door Water Deflector Replacement
.
- Raise and support the window in the full up position.
- Through the access holes in the inner door panel, loosen the window clamp nuts 4 revolutions.
- Connect the door trim panel wiring harness.
- Lower the window regulator 3/4 of the way down.
- Disconnect the electrical connector from the window regulator motor.
- Remove the window regulator bolts (1, 2, 3, 4, 5).
- Remove the window regulator from the door.
Installation Procedure
- Install the window regulator into the door.
Notice: Refer to Fastener Notice in the Preface section.
- Install the window regulator bolts (1, 2, 3, 4, 5).
Tighten
Tighten the bolts to 9 N·m (80 lb in).
- Remove the support from the window.
- Lower the window into the window regulator clamps.
The window must be fully rearward into the window channel when it is seated in the window clamps.
- Connect the power window motor electrical connector.
Important: Start the vehicle to ensure maximum power to the window motor. This is required to fully seat the window for adjustment.
- Start the vehicle.
- Raise the window to the full up position.
Tighten
Tighten the window clamp nuts to 11 N·m (95 lb in).
- Inspect the window for proper operation and fit.
- Shut off the vehicle.
- Install the water deflector. Refer to
Front Side Door Water Deflector Replacement
.
- Install the door trim panel. Refer to
Front Side Door Trim Panel Replacement
.
- Reprogramming the power window regulator. Refer to
Window Regulator Motor Programming and Setup
.