• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
---|---|---|---|---|
Body Control Module (BCM) 1 Fuse B+ | B1395 03 | B1395 03 | -- | -- |
Body Control Module (BCM) 7 Fuse B+ | B2652 00 | B2652 00 | -- | -- |
I/P Dimming Voltage Reference | B1395 03 | B2652 00 | B1395 07 | -- |
I/P Dimmer Switch Signal | B1395 03 | 1 | 1 | -- |
I/P Lamps Dimmer Switch Signal | B2652 00 | 1 | 1 | -- |
Indicator Dimming Control | B2625 00 | 1 | 1 | -- |
LED Backlight Dimming Control | B2610 00 | 1 | 1 | -- |
I/P Dimmer Switch Low Reference | -- | 1 | -- | -- |
I/P Dimmer Switch Ground | -- | 1 | -- | -- |
1. Interior Backlighting Malfunction |
The instrument panel (I/P) dimmer switch is used to increase and decrease the brightness of the interior backlighting components. The I/P dimmer switch provides a voltage signal that will increase as the brightness of the light are increased and decrease as the brightness of the lights are decreased. The body control module (BCM) provides a low reference signal and a B+ voltage reference to the I/P dimmer switch. When the I/P dimmer switch is placed in the desired position, the dimmed voltage setting is applied from the I/P dimmer switch through the I/P dimmer switch signal circuit to the BCM. The BCM interprets the signal and applies the dimmed voltage to the I/P lamps supply voltage circuit and the interior backlighting components dim to the requested level.
Battery voltage must be between 9-16 volts.
DTC B3600 03 will set when the BCM detects a short to ground or an open/high resistance in the I/P dimmer switch signal circuit.
• | The I/P dimmer switch will not operate. |
• | The I/P dimming lamps will not illuminate. |
• | The condition responsible for setting the DTC no longer exists. |
• | A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred. |
Interior Lights Dimming Schematics
Interior Lighting Systems Description and Operation
Control Module References for scan tool information
⇒ | If the test lamp does not illuminate, test the ground circuit for an open/high resistance. |
⇒ | If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM. |
⇒ | If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• | Control Module References for BCM replacement, setup, and programming |