1

Center Support Retaining Ring

Caution: Use care when removing or installing the retaining ring. Ensure the J 45126 is installed properly onto the retaining ring or bodily injury may occur.

Tip
To release tension on the retaining ring, place the retaining ring flat on the floor and step on it, then remove the tool.

Special Tool

J 45126 Snap Ring Pliers

2

Center (with 2-6 Low and Reverse Clutch) Support Assembly

3

Output Carrier Assembly and Output Shaft Assembly

Notice: Ensure the DT 47786 is completely threaded into the output shaft assembly. Due to the weight of the assembly, incomplete threading may cause the assembly to break free from the DT 47786, causing component damage.

Special Tool

DT 47786 Output Carrier/Shaft Lifting Tool

4

Output Shaft Thrust Bearing Assembly