GM Service Manual Online
For 1990-2009 cars only

Object Number: 1645510  Size: MF

Callout

Component Name

1

Molding Retainer Nut (Qty: 3)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
10 N·m (89 lb in)

2

Retainer Tab

Tip
Remove the tab prior to removing the exterior lower molding.

3

Double Sided Adhesive Molding Tape

  1. Clean all tape residue from the exterior door panel prior to installing the new lower door molding.
  2. The new molding must be at least 66°F prior to installing the molding to the body panel.
  3. Close the front door.
  4. Remove all 3 protective liners from the adhesive tape.
  5. Be careful not to touch the adhesive tape with hands or allow molding to come in contact with any dirt or foreign material prior to adhesion.
  6. Align the 13 retainer clips to the holes in the door.
  7. Apply hand pressure to secure the 13 molding retainer clips to the door.

4

Retainer Clip (Qty: 13)

Tip
Pull the molding from the rear edge carefully in order to disengage the retainer clips and remove.

5

Front Side Door Lower Molding

Tip
Ensure the front door is in the closed position when installing the new lower door molding.