Tools Required
J 39400-A
Halogen Leak Detector
Removal Procedure
- Recover the refrigerant from the A/C system. Refer to
Refrigerant Recovery and Recharging
.
- Raise the vehicle. Refer to
Lifting and Jacking the Vehicle
.
Important: Disconnect the LH muffler from the support hangers to gain access to the auxiliary A/C lines.
- Disconnect the LH muffler from the support hangers.
- Remove the auxiliary evaporator inlet line nut from the auxiliary HVAC module at the underside of the vehicle.
- Disconnect the auxiliary evaporator inlet line from the auxiliary evaporator.
- Disconnect the auxiliary evaporator inlet line from the body retainer clip.
- Remove and discard the O-ring.
- Remove the auxiliary evaporator outlet line nut from the auxiliary HVAC module at the underside of the vehicle.
- Disconnect the auxiliary evaporator outlet line from the auxiliary evaporator.
- Disconnect the auxiliary evaporator outlet line from the body retainer clip.
- Remove and discard the O-ring.
- Lower the vehicle.
- Remove the left body side trim panel. Refer to
Body Side Rear Trim Panel Replacement
.
- Disconnect the electrical connectors from the auxiliary HVAC module.
- Remove the air duct from the auxiliary HVAC module.
- Remove the auxiliary HVAC module bolts from the vehicle.
- Remove the auxiliary HVAC module from the vehicle.
Installation Procedure
- Install the auxiliary HVAC module to the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the auxiliary HVAC module bolts to the vehicle.
Tighten
Tighten the bolts to 9 N·m (80 lb in).
- Connect the electrical connectors to the auxiliary HVAC module.
- Install the air duct to the auxiliary HVAC module.
- Install the left body side trim panel. Refer to
Body Side Rear Trim Panel Replacement
.
- Raise the vehicle.
- Install new O-rings to the auxiliary evaporator inlet and outlet lines. Refer to
O-Ring Replacement
.
- Install the auxiliary evaporator outlet line to the auxiliary HVAC module.
- Connect the auxiliary evaporator inlet line to the body retainer clip.
- Install the auxiliary evaporator outlet line nut to the auxiliary HVAC module.
Tighten
Tighten the nut to 9 N·m (80 lb in).
- Install the auxiliary evaporator inlet line to the auxiliary HVAC module.
- Connect the auxiliary evaporator inlet line from the body retainer clip.
- Install the auxiliary evaporator inlet line nut to the auxiliary HVAC module.
Tighten
Tighten the nut to 9 N·m (80 lb in).
- Lower the vehicle.
- Connect the LH muffler to the support hangers.
- Recharge the A/C system. Refer to
Refrigerant Recovery and Recharging
.
- Leak test the fittings of the component using
J 39400-A
.